I was able to get the motors moving correctly with A4988s, as well as TMC2208s in standalone mode. I have a Ramps 1.4 board that I am trying to use with BigTreeTech's TMC2208 (v3.0) in UART mode with Marlin 2.0.9.2. If someone can assist me with this issue. I can provide conf.h and conf adv, but not sure it will help probleme I do not have with cartesian version.) (by the way for information, config.h and adv delta version remove some menu in lcd panel. I think, Issue is not in marlin firmware as I tried different one, at the end I was chnaging strict minimum but it failed every time with motor. With pronterface or lcd menu, if I make a G28 after few sec it crash printer. Try to turn cable connector between board and motor no changeĮverything else is working : endstop fan heater.

Try with power supply 12V and 24V no change version originale V2.0.6x V2.0.9.1 V2.0.9.2 even a cartesian version. Here is issue I have : I can not make work motors. I use visual studio for diferent version of marlin 2.0 I follow instruction from btt to make setup on SKR1.3+TMC5160

Download lightburn ramps 1.4